During the August holidays, the store will be operating in reduced capacity. Orders placed between August 14 and August 19 will be shipped on August 20th. Orders placed between August 24th and August 29th will be shipped on September 1st. Thank you for your understanding!

Product 3/9

Previous
Return to the Product List
Next

AfroMini 32

1,900JPY

This is a micro version of Naze32, designed for use with OpenAero32 or baseflight.

It is also available from the following resellers: USA1, USA2, USA3, Indonesia
Currently shipping rev3 BLACK 0.8mm thin boards. rev1 available by request, limited qtys.
  • 33mm x 16.5mm
  • 1.75 gram without headers
  • STM32F103CBT6 32-bit Cortex M3 processor
  • MPU6050 Accelerometer/Gyro
  • BMP085 Barometer (rev0)
  • BMP180 Barometer (rev1)
  • BMP280 Barometer (rev3)
  • Only supports PPM RC Input
  • 1 throttle, 4 servo outputs (for airplane mode)
  • 4 motor outputs for quadrotor mode (rev0)
  • 6 motor outputs for multirotor mode (rev1, rev3)
  • 2 3.3V analog inputs (for pitot etc in airplane mode, rev0)
  • Battery voltage monitor (rev3)
  • Futaba s.bus inverter built in (rev3)
  • Buzzer output (rev3)
  • Additional UART pads for GPS/Spektrum
  • Currently shipping version can be powered with up to 16V
Requires USB>3.3V serial cable (not included)

Currently shipping rev3 BLACK 0.8mm thin boards. 

Finally, this has a manual: DOWNLOAD for rev0-1a
Manual for rev3: DOWNLOAD

Note: This hardware cannot be used with any DJI frames. This includes: FlameWheel 330, 450, 550, or any future or past frames released by DJI.

Note: Using this hardware with anything other than supplied "baseflight" firmware will immediately make the end user ineligible for any kind of support or warranty.

Sold Out
  • Model: AFRO_MINI
  • Shipping Weight: 0.02kilograms
  • 0 Units in Stock
  • Manufactured by: AbuseMarK


This product was added to our catalog on Saturday 09 March, 2013.
Copyright © 2025 AbuseMarK. Powered by Zen Cart