FunFly Controller "NAZE32" [AIR32 Edition]

2,500JPY

STATUS: Back in stock with rev2a (added sonar pads and RX/TX uart broken out on main 3x6 header)

This is a mini version of NAZE32 Acro. This is a design cooperation with MultiWiiCopter Australia, based on the Paris Air Hero enclosure design. For more information and setup for this board, see MultiWiiCopter Paris Air Hero32 pages. A polycarbonate case is available for purchase from MultiWiiCopter.

PCB 37mm x 21mm
5 gram
STM32F103CBT6 32-bit Cortex M3 processor
MPU6500 Accelerometer/Gyro
BMP280 Barometer
Flex port for UART/I2C - support bluetooth or serial telemetry
Supports 6channel PWM or 8+ channel PPM RC Input
Directly supports S-BUS without need for inverter cable (connect S-BUS signal pin to RC channel 4)
Supports Spektrum satellite on Flex port
6 motor outputs for Tri/Quad/Hex or Quad + Gimbal
Can be powered by up to 16V directly (however note high voltage is passed through to receiver, so receiver must also be capable of 16V) input, unless using Spektrum satellite then it's OK.
Micro USB for setup with Baseflight Configurator.
Battery voltage monitoring (needs soldering)
Buzzer/high power LED output (needs soldering)

A manual for this might be available at some point, however it runs standard baseflight firmware, so all the same features of AcroNaze32 are supported. To mount the board with USB port facing "forward", do "set align_board_yaw=180" from CLI.

Included in package