ICs / Components
New Products ...
Featured Products ...
All Products ...
New Products [more]
iPad Retina 1536x2048 9.7" (QX2) LCD to Mini DisplayPort Adapter
HDMI to DisplayPort Active cable for 9.7" panel ONLY
FunFly Controller "NAZE32" [AIR32 Edition]
Shipping & Returns
Conditions of Use
Gift Certificate FAQ
:: FunFly Controller "NAZE32" (Acro version)
FunFly Controller "NAZE32" (Acro version)
Starting at: 2,500JPY
There might be a distributor carrying these boards near you! Check regional availability first:
LIMITED STOCK AVAILABLE, SAVE MY TIME AND ORDER FROM NEARBY DISTRIBUTOR INSTEAD!
Mini Flight Controller 「なぜ32」 (pronounced "NAZE32").
This version is same as
except that the only sensor is MPU6500 acc + gyro. Acro version comes with BMP280 low-resolution barometer, but no compass.
STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
Invensense MPU6500 MEMS accelerometer + gyro
BMP280 low-resolution baro for altitude logging, etc
Built-in Micro-USB for programming/firmware update
36x36mm size, ~5 gram weight w/o headers
Made in JAPAN
Since 08/10/2014, these are shipping with
input capable voltage regulators
These come with all needed headers, NOT soldered to the board. RC input breakout cable is included if selected below, to allow connecting to 4channel+ receiver.
Included: 1x AcroNaze32 rev6, 1x 2x5 header, 1x 3x6 right angle header, 1x RC breakout cable (if selected).
Configuration software - Chrome Baseflight Configurator (preferred)
NOTE: Untuk membeli barang ini secara terus di Malaysia, sila message ke Tapir Ting 0162388167 dan bayaran melalui maybank2u.
Note: Currently shipping rev6 boards in random colors. Hardware specifications and layout are subject to change without notice for improvement. Letter revisions (i.e. REV6A,B,C, etc) are for correcting non-critical issues or manufacturing optimizations.
Note: This hardware cannot be used with any DJI frames. This includes: FlameWheel 330, 450, 550, or any future or past frames released by DJI.
Note: Using this hardware with anything other than supplied "baseflight" firmware will immediately make the end user ineligible for any kind of support or warranty.
Shipping Weight: 0.04kilograms
0 Units in Stock
Include RC Breakout Cable
No, I have a PPM receiver or don't need the cable.
Yes, I don't have PPM receiver or I need the cable ( +100JPY )
Pin Header Type
Standard Vertical headers for all pins
Right-angle 3x6 header for motors, 2 vertical for other pins. ( +100JPY )
This product was added to our catalog on Tuesday 12 June, 2012.
Customers who bought this product also purchased...
5V Magnetic Buzzer
2048x1536 LCD to DisplayPort Adapter
STM32 Development Board (STM32F303CBT6)
QC Failed FunFly Controller "Naze 32" [Red, Rev6]
RFM23BP 915MHz Transceiver
RFM23BP 433MHz Transceiver
Copyright © 2016
. Powered by