FunFly Controller "NAZE32" (Acro version)

Starting at: 2,500JPY

STOP There might be a distributor carrying these boards near you! Check regional availability first: FPVMODEL (HK), Australia, Australia 1, Australia 2, Bulgaria, France 1, France 2, New Zealand, Singapore, South Korea, Indonesia, Finland, Netherlands 1, Netherlands 2, Spain, Spain, South Africa, UK1, UK2, UK3, UK4, Canada 1, Canada 2, Canada 3, Canada 4, International, USA1, USA2, USA3, , USA4, Taiwan.

国内の方はこちらからご注文下さい

LIMITED STOCK AVAILABLE, SAVE MY TIME AND ORDER FROM NEARBY DISTRIBUTOR INSTEAD!

Mini Flight Controller 「なぜ32」 (pronounced "NAZE32").

This version is same as http://abusemark.com/store/index.php?main_page=product_info&cPath=1&products_id=30

except that the only sensor is MPU6500 acc + gyro. Acro version comes with BMP280 low-resolution barometer, but no compass.

STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
Invensense MPU6500 MEMS accelerometer + gyro
BMP280 low-resolution baro for altitude logging, etc
Built-in Micro-USB for programming/firmware update
36x36mm size, ~5 gram weight w/o headers
Made in JAPAN
Since 08/10/2014, these are shipping with 16V input capable voltage regulators

These come with all needed headers, NOT soldered to the board. RC input breakout cable is included if selected below, to allow connecting to 4channel+ receiver.

Included: 1x AcroNaze32 rev6, 1x 2x5 header, 1x 3x6 right angle header, 1x RC breakout cable (if selected).

Configuration software - Chrome Baseflight Configurator (preferred)

https://chrome.google.com/webstore/detail/baseflight-configurator/mppkgnedeapfejgfimkdoninnofofigk

Download User's Manual.

NOTE: Untuk membeli barang ini secara terus di Malaysia, sila message ke Tapir Ting 0162388167 dan bayaran melalui maybank2u.

Note: Currently shipping rev6 boards in random colors. Hardware specifications and layout are subject to change without notice for improvement. Letter revisions (i.e. REV6A,B,C, etc) are for correcting non-critical issues or manufacturing optimizations.

Note: This hardware cannot be used with any DJI frames. This includes: FlameWheel 330, 450, 550, or any future or past frames released by DJI.

Note: Using this hardware with anything other than supplied "baseflight" firmware will immediately make the end user ineligible for any kind of support or warranty.